19
English
NOTE
○
Do not press the lock pin while the motor is rotating.
Also, do not switch the tool on while pressing the lock
pin.
Doing so may damage the lock pin and/or shaft as
well as result in injury.
○
Please limit the cutting depth of a single cut to under
13/16" (20 mm).
○
When cutting a deep groove, repeat the cut 2 or 3
times.
Deep cutting operations can make the tool di
ffi
cult
to control and may overload the motor, resulting in
malfunction.
○
Moving the tool forward fast may cause a poor quality
of cut, or damage to the bit or motor. Moving the tool
forward too slowly may burn and mar the cut.
The proper feed rate will depend on the bit size, the
kind of workpiece and depth of cut. Before beginning
the cut on the actual workpiece, it is advisable to
make a sample cut on a piece of scrap lumber. This
will show exactly how the cut will look as well as
enable you to check dimensions.
○
Abnormalities and overloads will trigger the overload
protector, and stop operation. Remove the load
immediately, and turn the power o
ff
, then on. The
rotation speed should return to normal.
(1) As shown in Fig. 30, remove the bit from the work
pieces and draw the switch trigger. Do not start
cutting operation until the bit has reached full rotating
speed.
Separate
Fig. 30
(2) The bit rotates clockwise (arrow direction indicated on
the base). To obtain maximum cutting e
ff
ectiveness,
feed the router in conformance with the feed directions
shown in Fig. 31.
Work piece
Rotation of bit
Router feed
Outer peripheral
cutting
(Counterclockwise)
Inner
peripheral
cutting
(Clockwise)
Fig. 31
5. LED light warning signals (Fig. 32)
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
activate during operation, the LED light will blink as
described in Table 5. When any of the safeguard
functions are triggered, immediately remove your
fi
nger from the switch and follow the instructions
described under corrective action.
Fig. 32
00Book̲M3612DA̲NA.indb 19
00Book̲M3612DA̲NA.indb 19
2020/11/18 9:52:41
2020/11/18 9:52:41
