16
English
(3) As shown in Fig. 21, securely attach the bottom of
the base ass’y to processed surface of the materials.
Feed the trimmer while keeping the guide plane on
the surface of the materials.
Body feed direction
Straight guide
Fig. 21
NOTE
When using the straight guide, be sure to install it on
the right side in the feed direction. This will help to
keep it
fl
ush with the side of the workpiece.
○
By exchanging the straight guide with the guide
holder, the tool can be used for circle cutting work.
[Processing range (distance from the enter of rotation
to the center of the bit)]
Minimum: 84 mm
Maximum: 182 mm
Note that circles measuring 102 to 124 mm and
143 mm to 158 mm cannot be processed.
(1) Turn wing nut and remove the bolt and washers
(2 pieces).
(2) Reverse the top and bottom of the straight guide and
attach it to the guide holder. (Fig. 22)
Guide holder
Bolt
Washer
Wing nut
Wave washer
Straight guide
Fig. 22
Depending on the radius of the circle to be processed,
the holes will vary for the wing nut and bolt.
Processing a circle with a radius of 84 to 102 mm
Center hole
Bolt
Washer
Wing nut
Wave washer
Processing a circle with a radius of 124 to 182 mm
Center hole
Fig. 23
(3) Installation to the tool is the same as that for straight
line processing.
(4) Align the hole of the straight guide left in the center
position of the circle processing, and
fi
rmly secure
with a nail less than 6 mm in diameter which will act as
a rotation axis.
Rotate the body towards the right. (Fig. 24)
Body feed direction
Nail (rotation axis)
Fig. 24
00Book̲M1808DA̲NA.indb 16
00Book̲M1808DA̲NA.indb 16
2020/12/25 10:37:38
2020/12/25 10:37:38
