14
English
APPLICATIONS
Wood and aluminum sash.
PREPARATION BEFORE OPERATION
CAUTION
Pull out battery before carrying out any
adjustment, servicing or maintenance.
When
fi
nished with a job, pull out the battery.
1. Power
source
Ensure that the power source to be utilized conforms
to the power requirements speci
fi
ed on the product
nameplate.
2. Power
switch
Ensure that the switch is in the OFF position. If the
battery installed to power tool while the switch is in
the ON position, the power tool will start operating
immediately, which could cause a serious accident.
3. Remove all packing materials attached or connected
to the tool before attempting to operate it.
4. Releasing the locking pin (Fig. 6)
When the power tool is prepared for shipping, its main
parts are secured by a locking pin.
Move the handle slightly so that the locking pin can be
disengaged.
During transport, lock the locking pin into the gear
case.
Locking pin
Handle
Fig. 6
5. Holder, clamp lever adjustment:
Attach the included holder in the position as shown
in Fig. 7 and adjust the holder until its bottom
surface contacts the work bench surface. After
adjustments, securely tighten the 6 mm bolt. Loosen
the M6 × 20 screw on the clamp lever and attach
to a position where the clamp lever can be easily
operated.
CAUTION
Attach the power tool to a work bench with bolts
(6 mm), and if the turntable has been swiveled
45° degrees or more, be careful not to let the
hand that is holding the side handle get caught
between the side handle and heads of bolts
(6 mm). Injuries could result.
Move
Adjust the holder
until its bottom
surface contacts the
work bench surface.
Holder
M6 × 20 Screw
Clamp lever
1/4 in. (6 mm) Bolt
Fig. 7
6. Install the side handle
Remove the M10 bolt and install the side handle that
came enclosed with this unit.
M10 Bolt
Fig. 8
7. Installation
11/32 in. (9 mm)
4 Holes
8-9/16 in.
(217 mm)
14-1/6 in. (360 mm)
00Book̲C1810DFA̲NA.indb 14
00Book̲C1810DFA̲NA.indb 14
2022/02/22 14:08:12
2022/02/22 14:08:12
