U16/14-100k
Date:
11/19/13
Manual
Page 7
6
Trouble shooting
The following trouble shooting list is provided to assist you while having
problems. It might let you use the system again without a long down time:
Error:
Possible reasons:
Solution:
No or erroneous
transmission
Transmission does not
start properly
Noise at output
Wrong power-up
sequence
Check documentation of
hardware and position
of switches
No transmission, DC
voltage at output
No optical signal at the
receiver
System (transmitter)
turned off
Check optical fibers and
connections, change
fibers if necessary
Turn on the devices
Transmission stops
Low battery
Signal of source
interrupted
Check LEDs at
transmitter and
receiver, recharge
batteries
Test source signal
directly at the device
under test
Device cannot be
turned on, cannot be
charged
Batteries damaged
Internal fuse is broke
Charger or cable
damaged
Batteries over
discharged
Send in device to the
manufacturer
Send in device to the
manufacturer
Check / replace charger
Charge batteries, maybe
use other charger (5
battery cells)
Output voltage does not
correspond to the
expected value
Voltage divider was not
taken into account
Erroneous transmission
of the settings
Wrong filter chosen /
filter not mounted
Set / Include ratio at the
oscilloscope
Turn off/on the devices
again, take care of
power-up sequence
Take operation purpose
into account (frequency
range and transmission
direction of the signal)
Distributed by: Reliant EMC LLC, 3311 Lewis Ave, Signal Hill CA 90755, 4089165750, www.reliantemc.com
