Messtechnik Sachs Irinos IR, User Manual

Page: 27 / 214

27
Irinos IR Users Manual © 2015 - 2016 Messtechnik Sachs GmbH, Germany
System overview
Ethernet interface. If only a few measurement channels are used, it
can be the only box used in an Irinos-System.
For the PC it does not matter, which type is used.
No general advice can be given, which type to use. This depends on
the measurement application and perhaps also on the requirements
made by the end customer. The following table lists the most
important advantages of each type:
Master Integrated Master
o
Better maintenance: all
measurement boxes of the
same input type are Slave-
Boxes. Thereby they are
identical -> less stock of
replacement boxes due to less
variants.
o
Variant available with 4 digital
in- and outputs and 3
analogue inputs ±10V.
o
Connection of additional digital
in- and outputs via IO-Bus.
o
Higher data throughput to the
PC with fast measurements
and many measurement
channels.
o
7-digit display for easier
diagnostics
o
No additional costs for
separate Master.
o
2 digital inputs, e.g. for push
button or foot pedal.
3.5 Digital in-/outputs (Bit-I/O)
The Irinos-System can be enhanced by digital in- and outputs. These
are intended to connect push buttons, foot pedals, proximity
switches, lamps, valves, etc. to the measurement software. Further
they can be used for data exchange between a PLC and the
measurement software (e.g. start measurement, stop
measurement, result ok, ...). Alternatively a ProfiNet module is
available.