3
English
2
Installation
2.1 Mounting the Camera
1.
Drill mounting holes and insert anchors.
In desired location, use the supplied Guide Pattern to drill three 5mm mounting holes. Then insert the supplied anchors
into the holes.
2.
Pass all the signal cables through the hole for the cables.
Optionally connect a video monitor to the BNC connector if you want to perform focus/zoom adjustments during the
installation.
3.
For static electricity protection, ensure that the rubber pad is placed inside the mounting bracket base.
4.
Place the three provided insulation caps onto the three tapping screws. Insert the screws to the screw holes on the
camera bracket, and then tighten the screws to the anchors to attach the camera .
Rubber Pad
Insulation Cap
2.2 Making the Connection
1.
Power(2-pin Red/Black):
Connect to AC 24V power supply. If you are to use power via the PoE connection, this
connector is not used.
2.
RJ-45 (PoE):
Connect to the LAN port of a standard 10BaseT/100BaseTX device, e.g., hub, switch or router. If you are
going to use PoE function, connect to a PoE-capable network device. Power will be supplied through the Ethernet
cable.
Note: Remember to use the RJ45 waterproof connector supplied to ensure waterproof protection.
3.
Alarm In (2-pin White/Black):
alarm signal input port
