MeshNetworks
1.
2.
3.
4.
5.
Mount the PWR in a traffic cabinet or kiosks. The device is not waterproof. The device should be
reasonable protected from moisture and other exposed outdoor environments. Refer to the
mounting procedure in the assembly section of this document.
Connect the antenna to the N-type connector.
Insert the Power Plug into Power Connector.
Verify the MAC address and ETH address has been recorded in
required to configure and test the device.
The Test Port is unused during deployment.
Figure 2-3
PWR6300 Cabinet Mounting
2.3.1 Deployment
When deploying the EWR6300, the antenna should be a minimum of 30 inches from any nearby
metal poles to avoid distortion of the RF pattern. The antenna must have a separation distance
of at least 2 meters from the body of all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter. Users and installers must be provided with
antenna installation and transmitter operating conditions to satisfy RF exposure compliance.
Typically, Portable Wireless Routers are distributed within a network and are used as wireless
routers. A rule of thumb is to deploy 2-3 hop networks to optimize range, latency, and
throughput to subscriber devices.
The PWR6300 installation location must provide applicable DC power for the device.
2.3.2 Deployment Tips
Locate the antenna to minimize multipath:
Minimize interference from nearby transmitters
4
