QUICK START
1
Install a 9-Volt Battery
[not included]
2
Enter
1-2-3-4-5-6-7-8-#
3
Turn handle before the
green
light turns off
4
To lock your safe, close door & turn
handle back to the locked position
IMPORTANT : Always make sure your safe is locked before walking away!
If your code is correct a
green
light will turn on for approximately
5 seconds
& you will also hear a ‘
Click
’
If the code is incorrect, a
red
light will turn on, followed by
5
‘
Beeps
’
NOTE : Be sure to press firmly & ONLY use your finger tips to press the
keys on the keypad. DO NOT USE your finger nail, a pen, etc. This will
damage the keys.
SAFE OPERATION & PROGRAMMING
1
st
USER CODE
is factor y set to :
1-2-3-4-5-6-7-8
2
nd
USER CODE
is factor y set to :
1-6-8
IMPORTANT : Because the codes are factory set, we highly recommend
changing the codes to your own unique codes immediately!
HOW TO OPEN YOUR SAFE
1
Input :
Code
-
#
[light stays green for
5 seconds]
2
Turn the handle to the unlocked position before the
green
light disappears
Example :
1-6-8-#
Invalid Code:
5
‘
Beeps
’
Wrong Tr y Penalty
If
3 wrong codes
are entered consecutively, the keypad will
shut down
for
a period of
15 minutes
. During this
shut down
period, the keypad will not
accept any codes.
CHANGING THE 1
ST
USER CODE
[Code length: 1-8 digit code]
NOTE :
Test the new codes several times before closing the door.
1
Locate the red button on the inside hinge side edge of the door
2
Press the red button
[Lock will ‘
Beep
’
2 times
with the
yellow
light on]
3
Input : Your
New Code
-
*
[lock will ‘
Beep
’
2 times]
Unsuccessful Code Change :
5
‘
Beeps
’ [old code is still valid; repeat 1 - 3]
PG.3
|
MSC SERIES MSL-50-
P
ELECTRONIC LOCK INSTRUCTIONS
