![background image](http://html1.mh-extra.com/html/meru-networks/ap1014i/ap1014i_installation-manual_1775110014.webp)
AP1014i LED Codes
© 2012 Meru Networks, Inc.
Installing AP1014i
5
1.
From the controller, click
Configuration > Devices > AP
, and then select the AP.
2.
Select one of these settings for the LED Mode setting:
—
Normal:
LED is as described above
—
Blink:
Sets the LED flashing; this is useful to locate an AP
—
Dark:
Turns off the LED
3.
Click
OK
.
The following table describes the colors that can be displayed by the AP1014i Status LED and the details
corresponding to each color sequence.
Color
State:
off
AP is off - either there is no power or the LEDs are set to
Off
on the
controller. Check the LED setting on the controller by clicking
Configuration > Devices > AP
, selecting the AP and then checking the
setting for LED Mode.
cyan
AP is booting stage 1.
green blinking
AP is booting stage 2.
green/white alternating
AP is discovering the controller.
green/blue alternating
AP is downloading a configuration from the controller.
slow blue blinking
AP is online and enabled.
rapid blue blinking
AP is online and enabled and there is activity on one or both radios.
red/yellow alternating
Some AP failure occurred; check the controller for more details about
the alarm by clicking
Monitor > Alarms > Pending Alarms
.
blue/yellow alternating
AP is online and enabled and one or both radios are either scanning or
an admin has taken the radio(s) down.