Meru Networks AP1000 SERIES, Installation Manual

Page: 105 / 135

Installing the Access Points
© 2010 Meru Networks, Inc. Installing OAP180
91
Test Basic Link Operation
Set up the OAP180 on the ground, either outdoors or indoors. Connect the unit as
indicated in this document and perform the basic configuration tasks outlined below.
When you are satisfied that the OAP180 is operating correctly, proceed to mounting
the unit in the intended location.
Mounting the Access Point
The
OAP180
can be mounted on the following (brackets are included):

2 to 3 inch diameter pole

Wall
Mounting OAP180 with the Pole-Mounting Bracket
Be sure to attach antennas (see Connect Antennas and Ground Wire to OAP180 )
before mounting an OAP180 on a pole. Follow these steps to mount the unit to a 2 to
3 inch diameter steel pole or tube using the mounting bracket:
1.
Attach the
OAP180
to the mounting bracket.
Figure 36: Square Mounting Bracket Attaches to Bottom of OAP180
2.
Place the V-shaped part of the bracket around the pole and tighten the securing
nuts just enough to hold the bracket to the pole. (The bracket may need to be
rotated around the pole during the alignment process.)
00199
Attach the adjustable
rectangular plate to
the bridge with
supplied screws
Note:
Always attach the bracket to a pole with the open end of the mounting
grooves facing up.