ADVANCED
50
|
To define the scene: set the desired settings for the scene on
the receivers. Then press the operating surface for about five
seconds. The settings of the receivers will be saved.
To retrieve the scene: briefly press the operating surface.
Setting up two different groups on one rocker
• Code:
[1004]
You can assign two different groups to the right rocker of the radio
push-button, for example (here: toggling). The left rocker keeps its
original functions (on/off; brighter/darker;
up/down).
Resetting a radio receiver to its
factory settings on the receiver
itself (by pressing 3x + holding
down) deletes only the
connections on the device itself.
It is still registered on the
internal list in the remote
control, taking up space in the
remote control's memory.
Deleting a radio receiver from the internal
configuration list
1
Switch to configuration mode.
2
Activate
ADVANCED?
.
3
Activate
COPY REMOTE?
.
4
Activate
RESET DEVICE?
.
– The display shows
WAIT DEVICE
.
Activate the learning mode on the radio receiver to be deleted
(by pressing 3x).
The remote control establishes a connection automatically.
– If the connection is established successfully,
OK
appears on
the display.
– Once the connection has been successfully established, the
radio receiver is deleted from the radio system.
– If the connection is not established successfully,
ERROR
appears on the display.
5
Exit the setup mode.
This section explains how you
can reset the settings for the
Merten CONNECT radio system
to the factory settings; in other
words, how to delete all saved
CONNECT settings.
Resetting the CONNECT settings to the factory
settings
This function deletes all CONNECT settings on the remote control;
in other words, it resets them to the factory settings.
This applies only to the settings for Merten CONNECT devices.
1
Switch to configuration mode.
2
Activate
ADVANCED?
.
3
Activate
SET DEFAULT?
.
– The display shows
SURE?
.
4
Confirm/activate with
[OK]
.
– The display shows
STARTED
.
– Following successful deletion, the display briefly shows
OK
before going back to
SET DEFAULT?
.
5
Exit the setup mode.
Summary of Contents for CONNECT 5069 SERIES
