merten CONNECT 5069 SERIES, Instruction Book

Page: 37 / 169

The essentials
35
Inserting batteries
1
Insert the batteries in the remote control (see section
“Changing batteries”).
|
When you insert the batteries for the first time, the remote control
goes directly into the Easy Connect configuration mode. You can go
straight to step
3
of the following section.
Devices in the CONNECT radio system
This section briefly explains how
you can program radio receivers
onto a key on the remote control
("learning" function). You can
then use the remote control to
operate the learned radio
receivers.
This quick reference guide is for
radio devices which are not yet
linked to a radio system (which
is the factory setting for the
devices).
The other configuration options
are explained in the other
sections of this instruction
manual.
1
Install and connect the radio receivers that you want to set up
for the remote control.
2
Press the SETUP key [ ] for three seconds.
– Wait until the status display goes out again.
– The display now shows
EASY CONNECT?
and the upper left
corner shows .
3
Activate
ADD ROOM?
.
– The display shows the default name for the new memory
area (e.g.
ROOM 1?
).
4
Activate the function
CONNECT KEY?
.
– The display shows
PRESS 1TO9/SCENE
.
– Select one of the numeric keys (1 to 9).
– The display shows
WAIT RCV
for 15 seconds.
– Activate the learning mode on the radio receiver (by pressing
3x): the remote control establishes the connection to the
receiver automatically.
When the connection is established,
OK
appears briefly and the
display then changes back to
CONNECT KEY?
.
Repeat step
4
for all radio receivers that you want to program
onto the same numeric key (max. 12).
5
Press the SETUP key [ ] for three seconds.
The essentials