Merrithew Health & Fitness Stability Chair, Owner'S Manual

Page: 7 / 12

merrithew.com
7
4b MoDEls WITH HaNDlEs
Lift the pedal to access the horizontal
frame and fasten the bottom end of the chair handle receptacles
[4] to the wooden sides [12] and the horizontal frame [11] using
two 1/4"x 2-1/2" hex bolt [19] and nuts [22] with washers [23] on
the outside only. Check that the three prong knob [2] at the top is
facing away from the pedals. Attach the top end of chair handle
receptacles [4] to the wooden sides, using two 1/4"x 1-1⁄2"hex
bolts [18] and nuts [22] with washers [23] on both sides.
NoTE: Chair handle receptacles [4] are specified as left and right.
6 MoDEl WITH HaNDlEs
Assemble the chair handles [15] and
chair handle chrome extensions [16] together using two 3⁄8"x 3⁄4"
hex bolts [20] with washers [24] and tighten.
NoTE: Chair Handles [15] and Chair Handle Chrome Extensions
[16] come as right and left.
5 all MoDEls
Place the chair seat [1] on top, aligning the edges
of the seat with the wooden sides [12]. From the underside, attach
the seat to the frame using four 1/4"x 2"hex bolts [21] with
washers [23]. Tighten all hardware.
7 MoDEls WITH HaNDlEs
Loosen the 3-prong knob [2] on the
chair handle receptacle [4], unscrew and pull out the pop-up pin [3]
and insert the chair handle [15, 16] fully into the receptacle.
Ensure that the bolt head faces out to not damage the vinyl of the
chair seat [1] and that the handle [15] faces towards the pedal.
Release the pop-up pin [3] ensuring it sits completely in one of the
holes and tighten the 3-prong knob [2] to secure the handle in the
receptacle [4]. There is no need to tighten the pop-up pin.
To adjust the handles, loosen the 3-prong knob [2], pull out the
pop-up pin [3], and position the handle at the desired height.
Release the pop-up pin, ensuring that it sits completely in one
of the holes and tighten the 3-prong knob. Make sure that both
handles are set at the same height.