defrost, turn the unit to the OFF position, remove the remaining cubes and prop door
open. It would be advisable to use a towel to absorb the melting frost to ensure it
does not escape the unit and create water damage.
C. STORAGE:
If the unit is to be stored or not used for a prolonged period of time, it is advisable to
drain the water system. Please follow these steps:
1.
Shut the water supply off to the machine.
2.
Disconnect the water supply from the water connection at the back of the
machine. Or, you may simply disconnect the water supply line behind the front
grill. The water valve has a ¼” copper tube with a compression fitting located on
top of the valve. Carefully disconnect this line. This is only advisable if you are
not willing to remove the installed icemaker. I3 models are not built-in and
disconnecting the quick disconnect fitting is advised.
3.
Allow the unit to operate for approximately one hour or so until the unit has
discharged all the ice in the mechanism.
4.
Dry out any remaining water left in the icemaker mechanism.
5.
Prop the door open.
6.
Disconnect the unit from the 115v power supply.
SECTION 7
(
TROUBLESHOOTING
)
A. WHAT TO CHECK FOR?
Before calling for service, please review the troubleshooting checklist below. Should
you still need attention, please don’t hesitate to contact us.
PROBLEM POSSIBLE
CAUSE
REMEDY
1) The unit is not
cold enough
Door gasket not sealed properly
Inspect the latch and gasket on door for
proper seal
Dirty condensing coil
Clean condensing coil. Refer back to
“
Care and Cleaning
” section
Summary of Contents for I-3
Page 3: ......
