Lift door onto positioning aids. Secure the moving panel in place with the door
holding seal SP010SP281000.
Loosely fix hinges to wall starting at the top. If needed insert packers provided
behind hinge plate to ensure even gap from top to bottom between closing edge
of door and Inline panel.
Ensure gap is between 6mm and 9mm then fully tighten the wall hinge screws.
Step 18
Step 19
11
12
INSIDE
INSIDE
6-9mm
To remove bottom positioning aids open door outwards.
Step 20
Measure distance between the wall and edge of inline panel. Cut infill seal on the
inline panel side to this length. Note the notched end of the seal is to be fitted to the
wall and the vertical fin is to the front.
Apply a dab of silicone to both ends, insert to bottom profile.
Step 21
INSIDE
21B
21D
21C
21A
