Merloni Elettrodomestici 85510, Service Information

Page: 14 / 20

14
CLOCK SETTING THE CREDAZONE1 & CREDAZONE4
Press the key and the value of the room temperature is displayed.
CLOCK ADJUSTMENT
Remember: 1 = Monday; 2 = Tuesday; ....... 7 = Sunday
CONGIFURATION CREDAZONE1
Note: -
Before the system can be controlled by the CredaZone, all Creda RF Receivers MUST first be
configured. Refer to RF Receiver First Time Installation and Configuration.
• Should more than one controller be used, the configuring decides which receiver is to be
controlled by which control unit.
• Take the CredaZone controller to each heater or ensure the controller is within range of the
heaters and begin configuring each heater.
• Set the controller (CredaZone1 or CredaZone4) to the configuration mode .
• Press and hold the + button for 3 to 5 seconds until the configuration mode CnF is displayed.
• Press the RF Re button again until the CnF display is replaced by '- -'.
• Set the CredaZone controller to the 'Auto' setting.
TEMPERATURE SETTINGS ON THE CREDAZONE1
Setting the Comfort Temperature
The Comfort temperature setting will be the temperature when the room is occupied.
The Comfort temperature setting ranges between 5°C and 30°C.
Set the Comfort temperature and record in the temperature box below.
* Insert temperature required.
Note:The Comfort temperature must be above the room temperature for the panel heater(s) to
switch on to the heating mode.
The CredaSaver Red neon will light to indicate when the RF Panel Heater is switched to the
heating mode.
By passing the 24.00 Hrs, the following day will display.
Quick pressing of the keys gives 1 minute steps.
Press and hold gives fast change.
*Temperature = °C