COPYRIGHT © 1999 MERIT INDUSTRIES, INC.
Site Preparation
•
Plug the game into a grounded
electrical outlet.
•
Plug the game into a separate circuit, if
at all possible. If a separate circuit is
not available, care should be taken to
provide a clean and constant voltage.
•
Place the game on a flat, level and
stable surface.
•
Place the game in a location that does
not interfere with its proper ventilation.
•
Make sure that all fans are operating
correctly and that airflow is
unobstructed. If any fans are not
operating, it is important that they be
replaced.
•
Make sure nothing is placed on top of
the cabinet or next to the fan vents that
would inhibit the flow of air.
Game Description
The base countertop model has 2 key-locked
compartments: the rear door section and
the coin drawer section. Each individual
sidecar has its own key-locked compartment.
CPU Section
The CPU section is accessible from the rear
of the unit in the countertop. The CPU
section houses the CRT, the monitor
controls, the CPU and I/O boards, the power
supply, the main harness, coin meter and the
connector board. The Dallas key is located
on the I/O board in the countertop model.
Coin Drawer Section
The coindrawer section is accessible from
the rear of the unit. This section is key-locked
for security purposes. A sturdy metal box
located within this section holds all coins
deposited into the machine.
Sidecar Installation
You can install a number of sidecar options
onto your EZ MAXX video game. To install
a sidecar, you will need to remove an endcap,
attach the desired sidecar and then re-attach
the endcap.
PM0235-02 MEGATOUCH™ EZ MAXX OWNER’S MANUAL 2
Removing an Endcap
To remove an endcap from the game:
1.
Unlock and open the rear door of the
game (or the rear door of sidecar, if
already attached) to gain access to the
endcap latches.
2.
Press firmly against the endcap, pull the
bottom endcap latch out of its notch and
push upward into the upper notch to
unlock (See Figure 10 on page 14).
3.
Repeat the above procedure for the top
latch of the endcap (See Figure 10 on
page 14).
4.
Remove the endcap from the game.
Attaching a Sidecar
After you have removed the endcap, you can
now attach a sidecar.
To attach a sidecar:
1.
Attach the sidecar spacer to the side
of the game by lining up the holes on
the spacer with the studs on the game
chassis (See Figure 9 on page 14).
2.
Next, attach the sidecar to the side of
the game by lining up the holes on the
sidecar with the studs on the game
chassis (See Figure 9 on page 14).
NOTE: BOTH THE SIDECAR SPACER
ANDTHE SIDECAR ITSELF SHOULD
BE FLUSH AGAINST THE FRONT OF
THE GAME.
3.
Using Figure 11as a reference, connect
the sidecar connector harness to the
connector board in the CPU section of
the game.
Replacing an Endcap
Once you have installed the sidecar, you will
need to re-attach the endcap to the game.
To replace the endcap:
1.
unlock and open the rear door of game
(or the rear door of sidecar, if already
attached).
2.
Line up the studs on the endcap with
Summary of Contents for EZ MAXX
Page 2: ......
