COPYRIGHT © 2004 MERIT INDUSTRIES, INC.
PM0450-03
MEGATOUCH FORCE FUSION MONITOR REPLACEMENT
5
7.
If you will not be reusing the existing
touchscreen, skip to the next step. If
you will be reusing the touchscreen,
note the orientation of the screen (i.e.,
the positioning of the ribbon cable and
which side is the front) before
removing it from the LCD monitor. Then
use dental floss to carefully cut the
foam tape holding the screen to the
monitor. Once the touchscreen is
completely free from the monitor,
remove any residual foam tape from
the screen with denatured alcohol and
clean the glass with the supplied
alcohol wipe.
Installing the Monitor
NOTE: Be sure the monitor glass is not
scratched during installation.
1.
If your replacement monitor already
has a touchscreen, skip to step 3. If
you will be using the original touch-
screen, clean the glass on the new
LCD monitor with the supplied alcohol
wipe, then cut pieces of the supplied
1/2” foam tape long enough to cover
each edge of the monitor without over-
lapping. After the tape is in place on
the monitor, peel off the backing.
2.
Carefully place the touchscreen over
the monitor in the same manner it was
attached to the old monitor, making sure
the screen is properly and evenly
aligned over the glass. Clean the front
of the touchscreen with the supplied
alcohol wipe once it is in place.
3.
Place the new LCD monitor in the bezel
(make sure it is not upside-down), lining
up the screw holes on the face of the
mounting frame with the larger, drilled
holes on the plastic mounting pieces
(see Figure 9), and fasten it with the
10 screws. Also replace the cable
clamps in the appropriate screw holes.
See Figure 8.
4.
Carefully replace the plastic bezel
assembly in the game, making sure the
coin cup protrudes into the lower
cutout and no wires are pinched, then
secure it to the wooden frame with
the 10 screws (see Figure 5).
5.
If the monitor has a new touchscreen,
connect the touchscreen controller
cable in the back of the controller and
secure the controller in the game with
the existing hardware. Then connect
the Molex connector (orange and gray
wires) to the main power harness and
attach the ground screw. Replace the
cables in the clamps as before. See
Figure 7.
If the monitor has the original touch-
screen, reconnect the touchscreen
controller cable to the LCD panel (see
Figure 6).
6.
Connect the VGA monitor connector
and ground screw (do not over-
tighten), the monitor control board
connector, and the monitor power
connector (see Figure 5) to the new
monitor and replace the cables in the
2 clamps attached to the monitor.
7.
Plug in and turn on the game.
8.
When the game is finished booting,
press the CALIBRATE button.
9.
Close and lock the bezel, then cali-
brate the touchscreen.
