COPYRIGHT © 2006 MERIT INDUSTRIES, INC.
Monitor Adjustment Procedure
For adjusting the settings on our monitors,
we suggest following the procedures de-
scribed below.
The vertical/horizontal con-
trols and brightness/contrast controls are
located on the control board, inside the CPU
section near the hinge of the door. Pressing
the button labeled
Menu
on the control board
will show the on-screen display on the moni-
tor. Use the
Left and Right
buttons to move
through the menu. Touch Menu again to
select the option you want to change. Use
the Left and Right buttons to change the
option. Then select Menu again to deselect
the option. Auto will automatically adjust the
size and brightness. Touch the
Exit
button
to exit. Adjust the monitor controls until the
screens look as suggested in the following
steps.
1.
Set the game to the Checkerz game
screen.
2.
Adjust the vertical and horizontal size
and vertical and horizontal position to
make sure that the game screen fills
the monitor screen and that the game
screen is centered.
3.
Adjust the brightness and contrast con-
trols until the top sets of checkers are
a rich red and the bottom set are a dark
gray. The feet on the
“Checkerz”
character should be white. (Adjusting
the brightness and contrast can also
correct for a lack of sharpness.)
General Circuit Board Handling
Information
Before handling any boards, observe the
following procedures:
•
Prevent Electro-Static Discharge by:
1. Storing the boards in the anti-
static bags in which they are
shipped.
2. Removing any static charge
from your body before handling
the boards.
3. Using a ground strap when
handling the boards.
•
When plugging in connectors to the
board, make sure the connector is
inserted straight onto the header and
that the connector covers all header
pins.
•
Do not connect any peripheral device
to the board, if the power is still
connected to the peripheral or if power
is already applied to the board.
CAUTION
: Be extremely careful when re-
placing the lithium battery on the mother-
board. There is a danger of explosion if the
battery on the motherboard is incorrectly
replaced. Only replace the battery with the
same type recommended by the manufac-
turer. Dispose of used batteries according
to the manufacturer’s instructions.
PM0480-13 MEGATOUCH EVO WALLETTE ION OWNER’S MANUAL 8
