29
Chapter 3: BIOS Setup Utility
Features Setup Page
This page sets up some parameters for peripheral devices connected to the
system.
CMOS SETUP UTILITY – Copyright (C) 1985-2004, American Megatrends, Inc.
Features Setup
Help Item
Allows BIOS to Enable or
Disable Floppy Controller.
OnBoard Floppy Controller
Serial Port1 Address
OnBoard IR Port
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
OnBoard PCI IDE Controller
Audio Device
Ethernet Device
MODEM Device
OnBoard USB Function
USB Function for DOS
USB 2.0 Controller
*****On-Chip Serial ATA Setting*****
On-Chip Serial ATA
Serial ATA Port0/1 Mode
Enabled
3F8/IRQ4
Disabled
378
ECP
DMA3
IRQ7
Both
Enabled
Enabled
Auto
Enabled
Disabled
Enabled
Enhanced Mode
P0-3rd/P1-4th
: Move Enter: Select +/-/: Value F10: Save Esc: Exit
F1: General Help F9: Optimized Defaults
OnBoard Floppy Controller
Use this item to enable or disable the onboard floppy disk drive interface.
Serial Port1 Address
Use this item to enable or disable the onboard COM1/2 serial port, and to assign
a port address.
OnBoard IR Port
Use this item to enable or disable the onboard infrared port, and to assign a port
address.
Parallel Port Address
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
Parallel Port Mode
This item decides the parallel port mode. You can select Normal, Bi-Directional,
EPP (Enhanced Parallel Port), or ECP (Extended Capabilities Port).
ECP Mode DMA Channel
This item assigns a DMA channel to the parallel port. The options are DMA0,
DMA1 and DMA3.
Parallel Port IRQ
This item assigns either IRQ 5 or 7 to the parallel port.
