Mercury MerCruiser Axius 350 MAG, User Manual, Page: 151 / 151

Section 8 - Customer Assistance Information
90-864197084 NOVEMBER 2008 Page 143
Wet Test Dealer
Confirm vessel personality list. ☐
Ensure the steering wheel returns to center position during key "ON" of starboard engine. ☐
Perform IMU (compass) calibration and zero heading correction. ☐
Maneuver the boat to port by moving the joystick to full port. Ensure undesirable movement can be corrected by
minimal operator joystick input.
☐
Maneuver the boat to starboard by moving the joystick to full starboard. Ensure undesirable movement can be
corrected by minimal operator joystick input.
☐
Ensure vessel tracks a straight course at cruising speed. Perform drive alignment if required. ☐
Enable AutoHeading and drive for one minute at cruising speed ensuring less than (± 5) degree deviation to port
or starboard.
☐
Check steering response by steering boat from lock to lock at different speeds, starting at idle and accelerating
through cruising speed in 1000 RPM increments.
☐
Perform a hard starboard turn at in‑gear idle while increasing to WOT while in turn. Ensure boat steering remains
responsive.
☐
Perform a hard starboard turn at in gear idle with both engines running. Turn the starboard engine off during the
turn. Ensure boat steering remains responsive.
☐
Safety Customer Dealer
Enable Throttle Only and demonstrate its ability to disable shifting of the electronic remote control
and joystick while engines are running.
☐ ☐
Joystick Customer Dealer
Demonstrate that the joystick requires both engines to be running to operate. ☐ ☐
Rotate the joystick to port and starboard to demonstrate pivot capabilities. ☐ ☐
Place the joystick to port to translate the boat while demonstrating the ability to compensate for
current and wind by rotating the top of the joystick and inputting slight forward and reverse inputs.
Repeat going starboard.
☐ ☐
Enable docking mode to demonstrate reduced throttle response for joystick maneuvers. ☐ ☐
Upgrades Customer Dealer
Demonstrate methods to enable and disable Auto Heading, if equipped. ☐ ☐
Demonstrate methods to enable and disable Skyhook, if equipped. ☐ ☐
Demonstrate methods to enable and disable AutoPilot Waypoint Sequencing, if equipped. ☐ ☐
Steering wheel Customer Dealer
Demonstrate that the starboard keyswitch is required to be on for steering wheel autocenter and
force feedback.
☐ ☐
Inform the consumer where the 20 A circuit breaker is located. ☐ ☐
Demonstrate the steering wheel autocenter ability and conditions. ☐ ☐
Maintenance Customer Dealer
Inform the consumer about hydraulic power steering fluid level checks and service intervals. ☐ ☐