2: Mainboard Installation
WOL1: Wake On LAN
If you have installed a LAN card, use the cable provided with the
card to plug into the mainboard WOL1 connector. This enables the
Wake On LAN (WOL1) feature. When your system is in a power-
saving mode, any LAN signal automatically resumes the system.
You must enable this item using the Power Management page of
the Setup Utility.
Pin Signal
1 5VSB
2 GND
3 -RING
Infrared Port
You can connect an infrared port to the mainboard. You can
purchase this option from third-party vendors.
1. Locate the infrared port
SIR1
header on the mainboard.
2. If you are adding an infrared port, connect the ribbon cable
from the port to the IR header and then secure the port to an
appropriate place in your system chassis.
Pin Signal Pin Signal
1 NC
2 KEY
3 +5V 4 GND
5 IRTX 6 IRRX
19
Summary of Contents for KOB 845G NDSMx
Page 4: ...Mainboard User s Manual IV...
