SPECIFICATIONS
33
Engine Break‑in
IMPORTANT: Failure to follow the engine break‑in procedures can
result in poor performance throughout the life of the engine and
can cause engine damage. Always follow break‑in procedures.
5 Hr. Break‑in Procedure
•
Allow engine to warm‑up for 30‑ 60 seconds.
•
Do not exceed 3/4 throttle.
•
Avoid full throttle acceleration from idle speed.
•
Always vary throttle setting.
•
Run engine the majority of time between 3000 ‑ 4500 RPM.
•
Frequently check engine oil level. Add oil if needed. It is normal for oil
consumption to be high during break‑in period.
After Break‑In Period
To help extend the life of your power package, Mercury Marine
recommends the following:
After 5 hr. Break‑in
•
Use a propeller that allows the engine to operate at or near the top of the
maximum RPM range (See
Specifications
section) when at full throttle
with a normal boat load.
•
Do not advance the throttle until the engine runs smoothly at idle and water
temperature reaches a minimum of 54 °C (130 °F). Do not operate at full
throttle until the engine oil temperature reaches 60 °C (140 °F).
•
Follow the maintenance schedule in this manual.
Summary of Contents for HP700 SCi
Page 4: ...iv...
Page 52: ...OPERATION 44 1 2 2 1 2 3 7867 1...
Page 123: ...115...
Page 124: ...COLD WEATHER OR EXTENDED STORAGE 116 a b f d e 16941 c...