P9
Please retain product label and instructions for future reference
DO NOT ALLOW YOUR CHILD TO PLAY WITH ANY
COMPONENT PARTS PRIOR TO ASSEMBLY.
Step 15
Parts needed -
Position the slide (No.13) on top
of the platform and the slide
framing (No.12) , ensure the slide
is pushed right up to the slide
frame and fix to the platform with
2x40mm screws.
2 x 40mm screws
40mm
screw
Note if fitting slide
1.
Please keep this instruction sheet safe for future reference.
2.
Inappropriate use or faulty application of the product is explicitly forbidden and absolves
the manufacturer of all liability.
3.
The assembly must be done by an adult.
4.
All elements of the item should be inspected regularly for eventual wear.
5.
This product meets to all safety aspects of the European standard EN71. It is only suitable
for domestic use, both indoors and outdoors.
6.
The product must be installed onto a playframe that is suitable for this activity (e.g. a
wooden tower). The assembly must be carried out in such a way that head, finger and
clothing entrapments are excluded. In order to prevent clothing entrapments during
gliding, there should be no openings around the platform between 3mm and 25mm. Pay
special attention to the boards of the platform onto which the slide is mounted.
7.
When mounting or assembling the product attention should be given to minimum required
distance between the product and eventual obstacles: walls, fencing,... The distance should
be minimum 2000mm.
8.
In this safety area no hard, angular or pointed objects should be present. The surface
underneath the product should be flat and shock absorbing, so no asphalt, concrete
or any other hard surface.
9.
The product must be mounted onto a suitable platform (see point 6) and only in accordance
with the recommended platform height with a tolerance of approximately 50mm (see notes
at the rear of the slide). The assembly must be done with 5mm or 6mm gauge countersunk.
The ground level surface must be suffuciently stable to avoid subsidence and to ensure that
the slide does not get damaged.
10.
It is strongly advised not to lift the slide from the bottom after it has been fixed to the
platform.
11.
To avoid the heating up of the product, do not orient the sliding surface towards the sun.
12.
Sliding can cause a small electrostatic charge. This can be avoided by not wearing synthetic
fabric clothing and/or by regularly cleaning the surface of the slide with water and soap.
13
www.merciagardenproducts.co.uk
4!
1!
2!
Pre drill
hole
50kg
13
If slide is purchased, position the
slide on the opposite side to the
door as shown in the diagams.
