I cut the existing “C” connector off but left about 2 inches of wire on that connector. The reason I did that
was to allow me to add an additional connector to that piece and the new harness adapter so I could
reinstall my Audio 30 unit if need be. You don’t have to do this and can route those five wires directly to
the C1 and C2 connectors using the pins listed previously. Below is a picture of the connector before I cut
it off.
And here is what it looks like after adding the additional connector (6 pin Molex … again not necessary …
me just being weird)
The wires removed from the “C” Audio 30 connector go to the C1 and C2 COMAND connectors as
follows:
C pin 1 --- goes to --- C2 pin 9 (brn/red CAN B high)
C pin 2 --- goes to --- C2 pin 8 (brn CAN B low)
C pin 4 --- goes to --- C2 pin 10 (blu/blk D2B wake-up)
C pin 5 --- goes to --- C1 pin 6 (red/blk CD c)
C pin 6 --- goes to --- C1 pin 5 (brn CD changer -)
