Mercedes-Benz GLC 200 4MATIC, Owner'S Manual

Page: 203 / 601

%
In the
F
drive program, some driving sys-
tems are restricted in their function or not
available. When selecting the F drive pro-
gram, a confirmation prompt therefore
appears on the central display before the
drive program is activated.
%
Plug-in hybrid: in the F drive program, you
can switch between hybrid and electric mode
via the multimedia system (
/
page 200).
Configuring DYNAMIC SELECT (multimedia sys-
tem)
Multimedia system:
4
©
5
Settings
5
Vehicle
5
DYNAMIC SELECT
Setting drive program I
#
Select
= Individual
.
#
Select and set a category.
Setting the H drive program
#
Select Hybrid .
#
Select Route-based or Standard .
If route guidance is active and the Route-
based option has been activated, the electri-
cal energy is distributed intelligently over the
entire route. In built-up areas, electric mode is
preferred, while on the motorway the internal
combustion engine is used.
With the
Standard option, the vehicle drives in
its standard drive program ( Î Electric or
n Hybrid ). There is no distribution of elec-
trical energy over the entire route. The high-
voltage battery is exhausted and the vehicle is
then driven by the combustion engine.
Switching the reset display on/off
#
Activate or deactivate Ask when starting .
%
This function must be activated for each user
profile separately. Only when this function is
activated will the drive program and ECO
start/stop setting for the previous journey be
saved for the respective user profile.
%
This function must be activated for each user
profile separately. The drive program for the
respective user profile of the last driver is only
stored if this function is activated.
Function on: the next time the vehicle is started a
prompt appears asking whether the last active
drive program should be restored.
Function on: the next time the vehicle is started a
prompt appears asking whether the last active
drive program should be restored. If the ECO
start/stop function was deactivated, an additional
prompt appears asking if the function should
remain deactivated.
% The prompt only appears if the previously
active settings deviate from the standard set-
tings.
Function off: the next time the vehicle is started
the
A
drive program is set automatically. The
ECO start/stop function is activated automati-
cally.
Function off: if the
Î drive program was the
last one active, and all requirements for the drive
program are fulfilled, this will be automatically
selected the next time the vehicle is started. If
another program was active, then the
m
drive
program is set automatically.
200 Driving and parking