Mercedes-Benz G 550, Operator'S Manual

Page: 211 / 288

Programming the remote control
Programming
Remote control in the rear-view mirror
Garage door remote control
A
is not part of
the garage door opener.
i To achieve the best result, insert new
batteries in garage door remote control
A
of your garage door drive before
programming.
X
Erase the memory of the integrated remote
control (
Y
page 211) before programming
it for the first time.
X
Turn the SmartKey to position 2 in the
ignition lock.
X
Press and hold one of transmitter
buttons
;
to
?
on the integrated remote
control.
After a short time, indicator lamp
:
will
start flashing. It flashes about once per
second.
i
Indicator lamp
:
flashes immediately
the first time that the transmitter button is
programmed. If this transmitter button has
already been programmed, indicator
lamp
:
will only start flashing at a rate of
once a second after 20 seconds have
elapsed.
X
Keep the transmitter button depressed.
X
Point garage door remote control
A
with
transmitter button
B
toward the
transmitter buttons on the rear-view mirror
at a distance of 2 to 12 inches (5 to 30 cm).
i The distance between garage door
remote control
A
and the integrated
garage door opener depends on the system
of the garage door drive. You might require
several attempts. You should test every
position for at least 20 seconds before
trying another position.
X
Keep transmitter button
B
on garage door
remote control
A
pressed until indicator
lamp
:
starts to flash rapidly.
The programming has been successful if
indicator lamp
:
flashes rapidly.
X
Release transmitter buttons
;
,
=
or
?
on the integrated remote control and
transmitter button
B
on the garage door
remote control.
If indicator lamp
:
goes out after
approximately 20 seconds and has not
flashed rapidly:
X
Release transmitter buttons
;
,
=
or
?
on the integrated remote control and
transmitter button
B
on the garage door
remote control.
X
Repeat the procedure for the other
transmitter buttons. When doing so, vary
the distance between the garage door's
remote control and the transmitter buttons
in the rear-view mirror.
i If the garage door system works with a
rolling code, you must synchronize the
remote control integrated into the rear-
view mirror with the garage door system
receiver after programming.
You will find further information in the
garage door opening system's operating
instructions, e.g. the sections on
"Synchronizing the transmitter" or
"Registering a new transmitter". You can
also call the hotline mentioned above.
Notes on programming the remote
control
Canadian radio frequency laws require a
"break" (or interruption) of the transmission
signals a few seconds after broadcasting.
Features
209
Loading, stowing and features
Z