Mercedes-Benz EQS 2021, Operator'S Manual

Page: 672 / 928

#
Tighten the wheel bolts evenly in a diagonal
pattern in the order indicated until they are
finger-tight.
#
Unscrew and remove the centring pin.
#
Tighten the last wheel bolt until it is finger-
tight.
#
Lower the vehicle (
/
page 670).
Lowering the vehicle after a wheel change
Requirements:
R
The new wheel has been fitted (
/
page 669).
* NOTE Risk of vehicle jack becoming trap-
ped by the AIRMATIC system
If the AIRMATIC system has released air when
raising the vehicle, the jack can become trap-
ped when the vehicle is lowered.
#
Start the drive system. This adapts the
vehicle level.
#
Remove the jack from under the vehicle.
#
To lower the vehicle: place the ratchet onto
the hexagon nut of the jack so that the letters
"AB" are visible and turn anti-clockwise.
#
Tighten the wheel bolts evenly in a diagonal
pattern in the order indicated 1 to 5 with
an initial maximum force of 80 Nm.
#
Tighten the wheel bolts evenly in a diagonal
pattern in the order indicated 1 to 5 with
the specified tightening torque of 150 Nm.
&
WARNING Risk of accident due to incor-
rect tightening torque
The wheels could come loose if the wheel
bolts or wheel nuts are not tightened to the
prescribed torque.
#
Ensure that the wheel bolts or wheel
nuts are tightened to the prescribed
tightening torque.
#
If you are not sure, do not move the vehi-
cle. Contact a qualified specialist work-
shop and have the tightening torque
checked immediately.
#
Check the tyre pressure of the newly fitted
wheel and adjust it if necessary.
% The following does not apply if the new wheel
is an emergency spare wheel.
#
Vehicles with a tyre pressure monitoring sys-
tem: restart the tyre pressure monitoring sys-
tem (
/
page 660).
670 Wheels and tyres
ohne