Mercedes-Benz 2013 GL X166, Operator'S Manual

Page: 95 / 448

opening range, up to approximately 4 in
(10 cm) before the stop.
This could be useful, for example, if there is
insufficient space above the tailgate.
X
To open the tailgate: pull the handle on
the tailgate.
X
To stop the opening procedure at the
desired position: press the closing button
(
Y
page 91) in the tailgate or pull the handle
on the outside of the tailgate again.
X
To store the position: press and hold the
closing button in the tailgate until you hear
a short tone.
The opening angle limiter is activated. The
tailgate will now stop in the stored position
when opening.
Deactivating
X
Press and hold the closing button
(
Y
page 91) in the tailgate until you hear
two short tones.
Tailgate emergency release
Important safety notes
! The tailgate swings upwards and to the
rear when opened. Therefore, make sure
that there is sufficient clearance above and
behind the tailgate.
i Opening dimensions of the tailgate
(
Y
page 441).
If the tailgate can no longer be opened from
outside the vehicle, use the emergency
release on the inside of the tailgate.
Opening
X Take the mechanical key out of the
SmartKey (
Y
page 82).
X Insert mechanical key
;
into the opening
in paneling
:
.
X Turn mechanical key
;
90° clockwise.
X Push mechanical key
;
in the direction of
the arrow and open the tailgate.
Side windows
Important safety notes
G
WARNING
When opening or closing the windows, make
sure there is no danger of anyone being
harmed by the opening/closing procedure.
The door windows are equipped with the
express operation and automatic reversal
function. If in express operation mode a door
window encounters an obstruction that
blocks its path, the automatic reversal
function will stop the door window and open
it slightly.
The door windows operate differently when
the switch is pulled and held. See the "Closing
when a door window is blocked" section in
this chapter for details.
The closing of a door window can be
immediately halted by releasing the switch or,
if the switch was pulled past the resistance
point and released, by either pressing or
pulling the respective switch.
Side windows
93
Opening/closing
Z