Mercedes-Benz 2010 GL 350 BlueTEC, Operator'S Manual

Page: 200 / 380

:
Key
;
Cover cap
=
Sticker FRONT (or REAR)
?
Screw for clamping claw
A
Clamping claw
The front and rear crossbars are of different
lengths. Please pay close attention to stickers
=
FRONT and REAR on the crossbars.
X
Unlock cover cap
;
with key
:
.
X
Remove cover cap
;
.
Sticker
=
indicating the location, FRONT
or REAR, becomes visible.
X
Turn screw
?
counterclockwise with the
included hex key until clamping claw
A
is
wide open.
B
Front crossbar
C
Rear crossbar
D
Gaps
E
Markings
F
Roof rails
X
Place front crossbar
B
between markings
E
on roof rails
F
.
i Markings
E
are located on the inside of
each roof rail, indicated by the white lines
in the illustration.
?
Screw for clamping claw
A
Clamping claw
F
Roof rail
X
Make sure clamping claw
A
lies flush
against the inside of roof rail
F
as shown
in the illustration.
If necessary, adjust clamping width of
crossbar (
Y
page 199).
X
Slightly tighten screw
?
on both sides by
turning it clockwise.
X
Place rear crossbar
C
on roof rails
F
in
such a way that the clamping claws reach
into gaps
D
(
Y
page 198) on the roof rails.
X
Make sure clamping claw
A
lies flush
against the inside of roof rail
F
as shown
in the illustration (
Y
page 198).
If necessary, adjust clamping width of
crossbar (
Y
page 199).
X
Slightly tighten screw
?
on both sides by
turning it clockwise.
X
On the front and rear crossbars tighten
screws
?
. Observe a tightening torque of
4 lb-ft (6 Nm).
G
Warning!
Have the tightening torque checked after
mounting the crossbars. The screws could
come loose if they are not tightened to a
torque of 4 lb-ft (6 Nm).
198
Loading and storing
Controls in detail
X164_AKB; 5; 31, en-US
d2ureepe,
Version: 2.11.8.1
2009-09-11T12:30:16+02:00 - Seite 198