Mercedes-Benz 2009 C-Class, Operator'S Manual

Page: 182 / 308

For information on messages in the
multifunction display concerning engine oil,
see the “Practical hints” section
(
Y
page 246).
Adding engine oil
! Only use approved engine oils and oil
filters required for vehicles with
Maintenance System. For a listing of
approved engine oils and oil filters, contact
an authorized Mercedes-Benz Center or
visit
www.mbusa.com (USA only).
The following will result in engine or
emission control system damage not
covered by the Mercedes-Benz Limited
Warranty:
R
Using engine oils and oil filters of
specification other than those expressly
required for the Maintenance System.
R
Changing of oil and oil filter at change
intervals longer than those called for by
the Maintenance System.
R
Using any oil additives.
CLS 550
CLS 63 AMG
X
Unscrew filler cap
:
from filler neck.
X Add engine oil as required. Be careful not
to overfill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.
! Excess oil must be siphoned or drained
off. It could cause damage to the engine
and emission control system not covered
by the Mercedes-Benz Limited Warranty.
X
Screw filler cap
:
back on filler neck.
For more information on engine oil, see the
“Technical data” section (
Y
page 296) and
(
Y
page 298).
Transmission fluid level
The transmission fluid level does not need to
be checked. If you notice transmission fluid
loss or gearshifting malfunctions, have an
authorized Mercedes-Benz Center check the
transmission.
Coolant level
The engine coolant is a mixture of water and
anticorrosion/antifreeze.
When checking the coolant level, the vehicle
must be parked on level ground, and the
coolant temperature must be below 158‡
(70†).
180
Engine compartment
Operation
219_AKB; 4; 54, en-US
d2ureepe,
Version: 2.11.8.1
2009-05-11T16:21:02+02:00 - Seite 180