EN
26
OPERATION
Starting the vacuum cleaner
1.
Press the suction hose into the intake open-
ing so that it clicks into place.
2.
Press the suction hose’s other end into the
hose pipe.
3.
Press the hose pipe into the floor nozzle.
Adjust the hose pipe to the required length.
4.
Hold the plug and pull out the power cord.
A yellow marking on the power cord shows
a suitable length of extension. Do not pull
out the power cord beyond the red marking.
5.
Connect the plug to the wall socket.
6.
Start the vacuum cleaner by pressing the switch.
7.
Press the switch to turn off the vacuum cleaner when finished vacuuming.
8.
Roll in the power cord by pressing the rewind button. Always hold the plug
while the cord is being rewound.
IMPORTANT!
The motor may overheat if the suction opening is blocked. The appliance is equipped with an
overload protection which shuts off the appliance if it is overloaded.
Adjusting suction power
Adjust the vacuum cleaner’s suction with the control button on the hose pipe.
Replacing dust bags
NB:
The vacuum cleaner must be turned off when replacing dust bags.
1.
Open the lid by lifting it at the front edge.
2.
Lift up the full dust bag.
3.
Put in a new dust bag.
4.
Fold the lid down and make sure that it locks in place correctly.
