ENGLISH
16
WARNING!
IMPORTANT!
If the hose becomes blocked while vacuuming, turn off the appliance and remove the
blockage before using the appliance again.
1.
Do not use the appliance close to heat sources such as radiators.
2.
Do not touch the plug if your hands are wet.
3.
Before vacuuming, remove large and/or sharp objects that can damage the dust container or hose.
4.
Do not pull the power cord to disconnect the plug from the mains socket.
5.
Do not use the appliance unless all the filters are in place.
6.
If the sound of the appliance becomes shriller while in use the air flow is blocked. Immediately turn
off the appliance, unplug the cord and clean the suction hose and/or clean the air filter.
NOTE!
A damaged power cord must be replaced by an authorised service centre or qualified person to
ensure safe use.
WARNING!
Always hold the plug when winding up the cord.
OPERATION
NOTE!
Always unplug the power cord before changing accessories.
1.
Push the suction hose into the intake opening until it clicks into place.
2.
Attach the other end of the hose in the tube.
3.
Attach the tube in the floor nozzle. Adjust the tube to the desired length.
Setting the suction force
NOTE!
Once all the accessories are fitted, extend the power cord to the required length and then plug in
the power cord. A yellow mark on the cord shows a suitable extension length. Do not pull out the power
cord further than the red mark.
1.
Plug in the power cord.
2.
Press the power switch to turn on the appliance.
3.
Wind up the power cord by pressing the wind up button. Always hold the plug when winding up the
cord.
4.
Adjusting the suction power by moving the speed control on the tube.
Wind up button
Power switch
