EN
22
• Handle the kettle carefully and do not
open the lid when it contains hot water
– risk of scalding.
• Pull out the plug when the kettle is not
in use.
Heating water to set temperature
1. Fill the kettle with water, put it on the
base and press the "+/-" button to set the
temperature (50, 70, 80 or 90°C).
2. The status light for the set temperature
goes on. Press the "100 °C" button.
3. The kettle heats the water to the set
temperature. When the water has
reached the set temperature all the status
lights go off and two audio prompts are
given.
4. Lift the kettle off the base and pour out
the water.
5. The kettle remains switched off until
started again using the power switch. The
kettle can be kept on the base when not
in use.
Keeping warm at the set
temperature
1. Fill the kettle with water, put in on the
base and press the "+/-" button to set the
keep warm temperature (50, 70, 80 or
90°C).
2. The status light for the set temperature
goes on. Press the "100 °C" button for
three seconds.
3. The kettle heats the water to the set
temperature. An audio prompt is given
when the set temperature is reached, the
status light for the set temperature flashes
with 1 Hz and the product switches to keep
warm mode.
4. The kettle keeps the water at the set
temperature for 30 minutes. The kettle
then switches off automatically and all the
status lights go off.
2. Pour out the water, and repeat.
NOTE:
The kettle holds 1.7 l.
HOW TO USE
Boiling water
1. Put the kettle on a level and stable
surface.
2. Lift the kettle off the base, press the
lock button to open the lid, fill with the
required amount of water and close the
lid. The kettle can also be filled through
the spout. Fill to at least the MIN marking,
but do not fill above the MAX marking
on the level indicator. If there is too little
water in the kettle it will switch off before
the water boils.
3. Put the kettle on the base plate and plug
the plug into a power point.
4. Press the button "100°C". The kettle
heats the water up to 100°C
5. The status lights on the control panel are
off during the heating and the status light
in the kettle goes red. The status light in
the kettle goes off when the temperature
of the water reaches 100°C and two audio
prompts are given.
6. Lift the kettle off the base and pour out
the water.
7. The kettle remains switched off until
started again using the power switch. The
kettle can be kept on the base when not
in use.
NOTE:
• Do not overfill – risk of splashing. Never
fill the kettle over the MAX marking.
• Check that the lid is properly closed
before plugging in the plug.
• The base can be turned 360 degrees to
simplify plugging into a power point.
Summary of Contents for 008384
Page 3: ...1 1 2 3 4 5 8 7 6 9 2 1 2 ...
