13 of 28
The stove will get very hot during use, therefore due care must be exercised.
Please use the glove when opera�ng air controls, door and ash pan.
Note: If the chimney is externally fi�ed or the stove has been
installed on a larger diameter clay chimney liner then on cold days
it maybe necessary to warm the flue using firelighters prior to
ligh�ng with wood.
1. Place two small dry split logs (¼ split) on the fire bed. Kindling
stacked as in the picture allows combus�on air to flow freely and
will aid igni�on. On top of the kindling two or more non toxic
firelighters.
2. Open fully Primary and Secondary air by pulling out the levers, this
provides the stove with a mix of primary and secondary air to help
establish the fire.
3. Light the firelighters and push door to closed posi�on, latch
in 1
st
posi�on so the door is open 2 mm*. (see picture) This provides
addi�onal combus�on air for start up and reduces condensa�on
on the door glass.
4. Once the flames from the logs are fully established, this can take
up to 10 min's . The door can now be closed. Slide the Primary air
inwards to the closed posi�on.
If the stove flames begin to falter and generate smoke in chamber
pull out primary lever again to re-establish the fire, it maybe
necessary to unlatch the door again un�l the fire is fully established.
5. Once the fire bed is established close primary air, slide the
secondary in by 50%, for the stove to burn cleanly plenty of
secondary air is needed, do not be tempted to shut the fire down
too early as this may cause smoke.
At nominal heat output, expect to refuel your stove approximately
once an hour. Check load weights for your model on the table on
page 6.
For op�mum combus�on efficiency the ter�ary air control should
be pushed in.
* NEVER leave the stove una�ended when the door is ajar in latch posi�on 1.
HOW TO LIGHT YOUR WOODBURNING STOVE
Push in Primary Air Lever Fully
4.
Reduced Secondary Air Supply
5.
50%
Full Primary and Secondary Air
1.
Arrange your Kindling & Logs as shown
Door Ajar to Aid Start-up
3.
2..
