Getting Started
MEN Mikro Elektronik GmbH
15
1.2
Configuring the Hardware
You should check your hardware requirements before attaching the F600 to a
CPU board, since most modifications are only possible when the boards are
disconnected. You should also stick to the following order.
The following check list gives an overview on what you might want to configure.
;
SATA external device
You can install an external SATA device, e.g. a CD-ROM drive. Suitable
standard cables are available.
Refer to
Chapter 2.4.2.1 Installing an External SATA Device on page 31
for more details.
;
SATA hard disk on board
You can easily install a 2.5" SATA hard disk. MEN offers a suitable hard disk.
Installation material is already supplied with F600.
See MEN’s
for ordering information.
Refer to
Chapter 2.4.1.1 Installing a Hard Disk on page 28
for a detailed
installation description.
;
SA-Adapters on board
The board is shipped without SA-Adapters installed. To use the UARTs, you
can install two SA-Adapters directly on the board.
Chapter 2.3.1.1 Installing SA-Adapters Directly on F600 on
for a detailed installation description.
1.3
Integrating the Board into a System
The F600 is suited as a side card for different MEN CPU boards. If you are not sure
if your CPU board is supported, please check the CPU’s data sheet.
If the F600 can be used with your CPU, attach it to the CPU board as is described in
the CPU board’s user manual.
1.4
Installing Driver Software
For a detailed description on how to install driver software please refer to the
respective documentation.
You can find any driver software available for download on MEN’s
!
