SC2500 User Guide Ver 2.1
May 6, 2003
Page 21 of 26
Pin #1
Pin #41
Pin #42
Pin #17
5.2.8 Make sure that pin one on the cable, on the SCSI controller and on the
SC2500 are correctly aligned. The SC2500 uses a square pad on the connector
to indicate pin one, and most cables are marked with a triangle on the connector
or a stripe on the cable itself to indicate the first pin.
5.2.9 Attach the power cable from the system power supply to the SC2500.
This cable is keyed and cannot be inserted backwards. At this point, installation
is complete.
5.2.10 Reattach the AC power cable to the system and power-up.
5.3 Power and Cable Attachments
The following diagram depicts the SC2500 as viewed from the connector
(Back View).
Back view of SC2500
5.4 Software Installation Procedure
With the SC2500 installed, the user can now treat the device as a standard
Direct Access SCSI device. Standard implementation of the SC2500 will
include building a partition table with FDISK and high-level formatting. Low
level formatting is not required, nor recommended. Refer to your system
documentation for detailed instructions.
