2. Mounting Instructions, continued
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
1. Place lower slot into lower bushing.
2. Rotate top slot into place.
3. Secure locking Mechanism.
4. Loosen Allen Bolt to adjust angle,
then re-tighten Allen Bolt.
CORRECT
Fully engaged
Locking mechanism
NOT CORRECT
Latch assembly
1 2
4
3
8. Loosely install the four Fork Clamps on the forks,
approximately 2" apart. (fig. 4)
9. Start with Fork Clamp Bushing adjusted to rear of slot
(fig. 6) Then adjust as needed and check for clearance.
(See warning above.)
10. Slip the windshield mounting plates and windshield
onto the fork clamps, (see fig. 5 and 7) and secure the left
and right side locking mechanism
11. Adjust the height, angle and alignment of the wind-
shield and tighten
ALL
bolts. (fig. 9)
Note: This is a detachable windshield, ALWAYS make
sure the Locking Mechanism is Fully Engaged after
installing the windshield! (fig 8)
Space Approx.
2" apart.
WARNING:
"Mounting clamps
backwards will cause
damage to your tank."
Throttle side,
front of bike
INCORRECT
CORRECT
#memphisshades
Fig. 3
Loosen Allen
Bolt to adjust
angle, then
re-tighten
Allen Bolt.
Fig. 9
Rubber boot
Cable adjuster
Jam nut
Cable end
Re-route inside
Fig. 1 & 2 for XL 833L Super Low ‘11 - ’14
Adjust Fork
Clamp as
needed and
check for
clearance.
Bushing
Assembly
(See
WARNING
)
Fig. 2
Fig. 1
