M-WRG-K
Installation manual
M-WRG-S
12
•
Seal the ventilation pipes on the outside with silicone
5. Install M-WRG ventilation unit
The following steps are identical for the installation of flush- and surface mount!
5.1 Remove unit cover
•
With both thumbs, press down the two hooks
on the bottom of the M-WRG ventilation unit
and at the same time grab the edge of the cover
with both index fingers and then carefully lift the
cover up and towards you.
5.2 Seal the stubs
•
Check the sealing tape,
make sure it goes all the way around the stub
5.3 Insert mounting screws
•
Put flat washers onto the screws, then insert
the mounting screws through the holes
•
Push the centering gauges onto the screws
so the tip of the screws stick out about 1cm
•
Surface-mount:
Use
Ø5x120mm
mounting screws
•
Flush-mount:
Use
Ø5x100mm
mounting screws
