Mellanox Technologies MetroX TX6240, Hardware User Manual

Page: 34 / 112

Installation Rev 1.1
Mellanox Technologies 34
Step 3.
Login as
admin
and use
admin
as password. On the first login, the MLNX-OS configuration
wizard will start.
Step 4.
To configure network attributes and other initial parameters to the system, follow the configu-
ration wizard as shown in
Table 9 .
Parity None
Flow Control None
Table 9 - Configuration Wizard Session - DHCP
Wizard Session Display Comments
Mellanox configuration wizard
Do you want to use the wizard
for initial configuration? yes You must perform this configuration the first time you operate the
system or after resetting the system. Type ‘y’ and then press
<Enter>.
Step 1: Hostname? [switch ] If you wish to accept the default hostname, press <Enter>. Other-
wise, type a different hostname and press <Enter>.
Step 2: Use DHCP on mgmt0
interface? [no] yes Perform this step to obtain an IP address for the system. (mgmt0 is
the management port of the system).
If you wish the DHCP server to assign the IP address, type ‘yes’
and press <Enter>.
If you type ‘no’ (no DHCP), then you will be asked whether you
wish to use the ‘zeroconf’ configuration or not.
If you enter ‘no’ (no Zeroconf), you must enter a
static
IP, and the
session will continue.
Step 3: Enable IPv6? [yes] The management interface will be able to use IPv6 addresses.
Step 4: Enable IPv6 auto-config
(SLAAC) on mgmt0 interface?
[no] This turns on auto-configuration of the IPv6 addresses. This is
unsuitable for DHCPv6.
If you enter "no" (no IPv6), you will automatically be referred to
Step 6.
Step 5: Enable DHCPv6 on
mgmt0 interface? [no] To enable DHCPv6 on the MGMT0 interface.
Table 8 - Serial Terminal Program Configuration (Continued)
Parameter
Setting