37
PRIOR TO FIRST USE
• Remove all packaging and
transport materials from the inside
and outside of the appliance.
• Check that the appliance has no
visible damage and that no parts
are missing.
• Before using the appliance for
the first time (or after prolonged
storage without use), wash any
parts that will come into contact
with food. See “Cleaning”.
• If desired, lubricate the
attachments (12-19) and the holder
(11) using a little vegetable oil
before use to avoid staining from
strongly coloured vegetables such
as carrots and beetroot.
USING THE APPLIANCE
Assembly
1. Place the base unit (8) on a flat
surface, e.g. a kitchen counter, and
make sure it is standing firmly.
2. Push the collection tray (5) into
the base unit and ensure that the
handle end faces outwards.
3. Install the chosen attachment into
the holder, depending on what
you are going to use the appliance
for (see the section about the
individual attachments below).
Turn the holder so that the pin on
the small handle faces upwards.
Place the attachment in the holder
so that the small round hole in the
attachment fits over the pin on the
left side of the holder.
4. Place the holder with the installed
attachment onto the base unit so
that the rollers rest on the inside
edge. The end with the small
handle should be placed in the
furthermost end of the base unit.
5. Place the lid (6) onto the base unit
whilst ensuring that the slit in the
lid fits over the pin on the holder’s
small handle. Press the lid until it
clicks into place. Using a finger,
check whether the holder can be
moved freely back and forth.
6. Install the motor unit (9) above the
lid, so that it fits down over the pin
in the slit and the two pins at the
top of the lid.
7. Decide whether to use the large
(7), medium (3) or small (2) feed
tube, depending on the size of the
vegetables you are going to chop/
slice. Select the corresponding
pusher that matches the size of the
feeder opening. See explanation in
the table below.
8. The locking ring (4) fixed around
the medium-sized feed tube is
equipped with a tongue that acts
as an off button. The tongue
should be fitted into the recess
around the activation pin (10) on
the motor unit before the appliance
can be started. The appliance is
designed so that this part is always
used, either as a feed tube or as a
part of the large pusher.
9. The appliance is now ready for
use.
Feed tube
To be used with
Large feed
tube
(80 mm
diameter)
Large pusher (=
medium feed tube
+ small feed tube +
small feeder) (1+2+3)
Medium feed
tube
(60 mm
diameter)
Medium pusher (=
small feed tube +
small pusher) (1+2)
Small feed
tube
(40 mm
diameter)
Small pusher (1)
NOTE!
• NEVER put fingers, utensils or
similar into the feeding pipe or
collection tray whilst the appliance
is in use.
• NEVER use fingers, kitchen
utensils or similar to push
ingredients down the feed tube.
Always use the pusher.
