If for remote control setup has been used the
BRAND RESEARCH
procedure, obtain and make a note of the code in use as
follows:
• Press and hold on the MELICONI remote control for at least 6 seconds both
[
P +
]
e
[
+
]
buttons to extract the TV code (or
[
P +
]
e
[
P
–
]
for DECODER code).
• When the indicator light starts flashing, release and immediately briefly press the
[
EXIT
]
button.
• After a pause of several seconds, the indicator light produces four sets of flashes, spaced out,
corresponding to the code to be obtained. Count the number of flashes. Each set of flashes
corresponds to one digit in the code. Ten flashes correspond to the digit zero “0”.
(
example
code obtained =
1701)
• Make a note of the code obtained on the label on the inside of the battery cover. You may need it
in future.
●
IF THE REMOTE CONTROL IS NEW AND YOU CAN NOT MAKE IT WORK
Check that you have carried out all the settings procedures correctly. If necessary repeat them, following all the steps
indicated carefully.
The code set in the remote control is incorrect for the device that you want to control. Consult the
website to fi nd the correct code for your device. Or try entering all the codes for the same brand shown on the website or
received via SMS one by one and check which one works.
●
IF THE REMOTE CONTROL STOPS WORKING
Remove the batteries, press some buttons and insert NEW batteries. Make sure that the remote control is pointing at the
device without any obstacles between them.
Also try entering the code used to set the remote control again.
●
IF SOME FUNCTIONS ARE NOT AVAILABLE ON THE REMOTE CONTROL
Usually the MELICONI remote control makes available only the present functions on his keyboard, provided they are
available also on the original remote control.
If some of the MAIN functions are not available, you are probably using an incorrect code. Find and set a more suitable code
as described earlier.
●
HOW TO CHECK IF THE REMOTE CONTROL SENDS INFRARED SIGNALS
The human eye is not able to detect infrared signals; use a camera (even that of the mobile phone).
Aim the infrared LED located in front of the remote control (not the red LED above) and press and hold on the remote control
the
ON/OFF
[
]
button.
If you see through the camera, the LED light with short white / light blue flashes means that the remote control works and
emits infrared.
ATTENTION!
Most problems are caused by using insufficiently charged batteries.
We recommend checking them and, if necessary, replace them as shown in the
INSERTING THE
BATTERIES
chapter.
TROUBLESHOOTING
DISPLAY CODE IN USE
