6-3
3. Below the flywheel, remove the plastic cap and
place 1-2 drops of lubricating oil in the tube
shown in Figure 6-6 once every month. Replace
the plastic cap when done.
4. Remove the plastic caps over oil holes #1 and
#2, as shown in Figure 6-7.
5. Inside oil hole #1, place 1-2 drops of oil onto
the shaft as shown in Figure 6-8, Detail “A”,
once each month.
6. Inside oil hole #2, place 1-2 drops of oil onto
the connecting arm shaft, as shown in Figure
6-8, Detail “B”, once each month. A small
flashlight will help to locate the right spot.
7. Inside oil hole #2, place 1-2 drops of oil onto
the other end of the connecting arm shaft, as
shown in Figure 6-8, Detail “C”, once each
month. Rotating the flywheel will help move
the connecting arm into the correct position.
Replace the plastic caps when done.
8. Open the face cover. Referring to Figure 6-9,
Detail “A”, place 1-2 drops of oil in the upper
oil hole of the main connecting rod each
month. Rotating the flywheel will help move
the connecting rod into the correct position.
Also place 1-2 drops of oil at the base of the
spring each month.
9. Referring to Figure 6-9, Detail “B”, place 1-2
drops of oil in the lower oil hole of the main
connecting rod each month. Rotating the fly-
wheel will help move the connecting rod into
the correct position.
11034 Rev. A
6. Operator Maintenance
Figure 6-6
Flywheel
Place 1-2 drops
of oil into this
tube once each
month
Figure 6-7
Oil hole #1
Oil hole #2
Figure 6-8
Detail A
Detail B
Detail C
Oil here
Oil here
Oil here
Figure 6-9
Detail A
Detail B
Upper hole
Lower hole
Spring
Summary of Contents for EP 1
