Melco EP 1, Installation, Operation And Maintenance Manual

Page: 27 / 44

4-3
Run Design
Press [MENU] until the display reads RUN DESIGN, then press [ENTER]. The display will read SET
QUEUE 01, then will display your chosen file name. Up to 28 queue settings may be assigned and
their designs embroidered one after another. Once a file has been embroidered, it will be removed
from the queue if the auto delete feature is activated and the next file in the queue will be select-
ed. If the design is sent from the controller computer using the Auto Run feature, it will automati-
cally be added to the queue.
NOTE: If you are embroidering one design at a time, always make certain the display reads:
QUEUE 01. This ensures you are always embroidering the “current” design and not a
“previous” one.
Frame Menu
Press [MENU] until the display reads FRAME MENU, then press [ENTER]. The display will read
FRAME BACK. Press [
ð
] and the display will read FRAME FORWARD.
Press [STOP] once and release, and the machine will “back up” or “move forward” one stitch.
Press and hold for 5 seconds and the machine will frame backward or forward continuously, even
after the key is released, until [STOP] is pressed again. This operation will stop automatically at the
origin, end point, or next color change.
Press [
ò
] and the display will read RETURN TO ORIGIN. Press [ENTER] and the display will read:
FRAME FORWARD. Press [START] and the hoop will move to the point of origin for the last design
sewn.
Trace Menu
Press [MENU] until the display reads TRACE MENU, then press [ENTER]. The display will read CEN-
TERING OFF. Press [
ð
] and the display will read CENTERING ON. Press [ENTER] and the display will
read CALCULATING. Once the design outline has been calculated, the display will read TRACE
OUTLINE. Press [ENTER] and the display reads TRACE FILE1. Press [START] and the hoop will move
beneath the needle to trace the outline of the selected design.
If the outline of the design is larger than the hoop, the alarm will sound and the display will read
FRAME OVER. If no design was selected, the alarm will sound and the display will read RUN JOB
ERROR.
Hoop Selection
Press [MENU] until the display reads HOOP SELECTION, then press [ENTER]. You are offered four
different hoop choices. Press [
ñ
] or [
ò
] to select a hoop type and size, then press [ENTER]. The
chosen hoop will remain selected even after the power has been turned off.
NOTE: Hoop sizes cannot be changed during embroidering.
11034 Rev. A 4. Detailed Operation