ENGLISH
WS 931
Melchioni S.p.A.
10
maintain and repair it. Self-disassembly may result in the danger of electric shake, and in
the risk of losing the right of the counterclaim based on the quality guarantee.
•Only the voltage and frequency marked on the data plate can be used by the weld
machine.
•the weld machine can only be installed in the dry workshops to operate.
•the weld machine in operation must be looked after by workers.
•the weld machine can not operate or be put aside within the reach of the children.
•the weld machine can not be used under the wet circumstances or near the easily flaming
or the plosive materials or air.
•during the welding , it will produce welding evaporation, so welding can only be allowed in
the draught workshops.
•welding can only be carried out on the components with no electricity.
•You have to obey the corresponding regulation of safety protection, if the weld is used in
the industry.
•if the weld machine is moved from the cold room to the warm room, the temperature will
be changed, which will cause the congealed water which will affect or damage the
components of the machine, please wait to weld until the temperature of the weld machine
is the same with that in the room.
•the temperature of the electric soldering irons can reach more than 160•,if the animal or
man touch the metal heated by the electric soldering irons, we will suffer seriously bum.
•It supposes that the weld machine should not be operated under high temperature
•Preparation
Please conserve the weld machine’s packing box. In case that we use it for future
transportation or put the weld machine into it when we don’t need it ,so as to avoid
pollution of ash and the eroding of the wet.
1. put the metal helix of screw frame into the corresponding open crust of the electric
soldering irons frame. And use the screw to fasten it and so does the bottom of the
frame.
2. Please let the sponge for tidying up glue absorb enough clean water and drop to dry,
and then put it on the salver.
2. Fix the frame on the right side of the weld machine (connecting in gap)
Instruction:
Don’t use the electric soldering iron without soldering mouth because it will damage the
heating component and temperature sensor.
Electric connect
1. Please connect the electric soldering iron with the weld machine by means of insetting
the plug of the electric iron lead (a diode plug with 5 conjunctions and 180
degrees lead
trough) into the electrical outlet on the face of the weld machine.
3. Turn off the switch of the power supply (0 location), and inset the power supply plug of
the weld machine lead into the electrical jack whose voltage conforms with what is
marked on the data plate. At that time, the weld machine is ready for work.
