the lock of the water tank (
6
) to refill the water till the light
off.
5a. Push down the tank lock (
6
) then pull it out ; fill the water
accdording to real need. It will be regarded water empty when less
than 60
±
20g left in the water tank.
NOTE:
during the filling operation, be careful that the water does
not overflow as it may come out and wet the surface where
the Steam Station is laid.
____INSTRUCTIONS FOR USE_____
STEAM IRONING
1b. Set the iron temperature to the “MAX” steam position, by turning
the knob (
2
). All types of fabric can be ironed at this temperature.
2b. Wait for the indicator light of steam (
9
) goes on and the steam
button light (
5
) goes off. Push button (
3
) on the iron to release
bursts of steam form the holes on the soleplate.
Use the “Steam Holding System”(
11
) can keep the steam burst without
the finger pressure.
Release the button and the steam will stop.
3b.After using, you could put the power cable
on the bracket for winding wire.
NOTE:
during initial operation of the iron, a few drops of water
mixed with steam may come out of the soleplate until the
temperature stabilizes. It is advisable to direct the first
jets of steam onto an old cloth until a uniform stable jet
of steam is obtained.
_________IMPORTANT__________
·
Do not leave the iron unattended whilst connected to the mains.
·
Iron only on heat resistant surfaces and on surfaces that allow the
steam to escape e. g. mesh ironing boards.
·
The indicator light of steam (
5
) may go on and off from time to time
during use of the Steam Station. This indicates the machine
maintaining the correct and constant pressure and is quite normal.
·
If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or similarly qualified person in order to avoid
Summary of Contents for Shuttle
Page 13: ......
