Melchioni CALIDO 158640045, User Manual

Page: 12 / 44

11
•
Ensure that the power cord is correctly positioned and does not come into contact with
hot parts or sharp edges, or become wound around the appliance itself and is not twisted.
•
Do not hang or even lean the appliance against any walls.
•
Place the fan heater far from any other source of heat, from flammable material
(curtains, tapestries, etc.), from flammable gases or explosive objects (spray cans) and
from materials that can be deformed by heat. Make sure there is 120 cm of free space in
front of the fan heater and 50cm free space on both sides and behind it.
•
The surface where the appliance is used must be stable, spacious (do not use on shelves),
level (since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use:
run the appliance to eliminate the "new smell" and any oil residue from the
manufacturing process for at least 10/15 minutes. During this operation, ventilate the room
well to eliminate the "new smell" that is given off by the appliance.
Connect the appliance to the power socket, the operation light will turn on.
To turn on the appliance, turn the knob clockwise to the desired position:
“0” = off; “ ”= fan on; “ I ”= hot air (750W); “ I I ”= very hot air ( 1500W)
Swing switch: “ ” swing ON, “ ” swing OFF
- The thermostat adjusts the ambient temperature, and is greater when the selector is
turned towards the maximum position (clockwise direction): once the temperature has
been reached, it will be kept constant, while setting it to the lines in between causes the
element to come on at intervals.
- The indicator light turns on and off when the appliance reaches the set temperatures.
- The base has an anti-tipping switch, which allows the appliance to run while the fan
heater is correctly positioned (when correctly placed you will hear it "click") but stops
operation if the appliance tips over.
- safety device: when included it stops operation in the event of overheating. To restore
operation, remove the plug from the mains and wait for it to cool (about 20 minutes) and
insert the plug into the plug point and turn on again.
To use the fan heater, proceed as follows:
1) Plug into the socket.
2) Adjust the thermostat knob to the required ambient temperature.
3) Turn the appliance on by turning selector switch clockwise to the required setting.
4) To turn the appliance off, turn the adjustable thermostat in pos.min, selector switch
to “0” and remove the plug from the mains.
If the appliance is not being used for long periods of time, remove the plug from the plug
point.