MeiTrack MT90A, User Manual

Page: 7 / 15

MEITRACK MT90A User Guide
Copyright © 2014 Meitrack Group All rights reserved. - 7 -

In standby mode, press and hold down the button for 2s, when the buzzer
sounds “BI” once, the recorder will run automatically. (The MT90A will record
the route every 30s automatically when a GPS signal can be received. Route
records can be exported by using a computer.

Press and hold down the button for 2s again, when the buzzer sounds “BI”
twice, and the recorder will stop automatically.
Note: To avoid misoperations, you can disable the GPS Log button by using Meitrack
Manager (default: valid).
10 Volume-/GPRS
button

Press the button to turn down the volume.

In standby mode, press and hold down the button for 2s, when the buzzer
sounds “BI” once, the GPRS function will be enabled automatically.
(Precondition: GPRS parameters are set, and the default GPRS message
interval is 10 minutes.)

Press and hold down the button for 2s again, when the buzzer sounds “BI”
twice, the GPRS function will be disabled automatically.
Note: To avoid misoperations, you can disable the GPRS button by using Meitrack
Manager (default: invalid).
11 Lanyard hole Place the lanyard through the hole.
12 Battery cover After removing the battery cover, install the battery and SIM card.
5.2 Indicator
To start the MT90A, press and hold down the power button for 3 to 5 seconds. The blue and green indicators blink on for 1s
and blink off for 1s simultaneously.
GPS Indicator (Blue)
Status Description
Steady on The MT90A is charging.
Blink every 5s The MT90A is in sleep mode.
1s on and 1s off The GPS is invalid or the MT90A is initializing.
Off The GPS is valid.
GSM Indicator (Green)
Status Description
Steady on A call is coming in or busy.
Blink every 5s The MT90A is in sleep mode.
1s on and 1s off No signal is received, or the MT90A is initializing.
Off The MT90A is connected to the GSM network.