14
Programming Procedure
•
To enter programming, press and hold the
SELECT button for three seconds -
“PROGRAM” (flashing) and the days Mon-Fri will
appear on display.
•
Press the “+” or “-” buttons, “PROGRAM 1” and
“START” (flashing) will appear on display.
•
Press the “+” or “-” button - the hours will flash.
•
Adjust the hours using the “+” and “-” buttons.
•
Press the “Select” button - the minutes will
flash.
•
Adjust the minutes using the “+” and “-”
buttons.
•
Press the “Select” button again – “COOL”
(flashing) and the set-point temperature for
cooling will appear on display.
•
Adjust the set-point temperature for cooling
using the “+” and “-” buttons.
•
Press the “Select” button again – “HEAT”
(flashing) and the set-point temperature for
heating will appear on display.
•
Adjust the set-point temperature for heating
using the “+” and “-” buttons.
The controller keeps a safety differential of at least 1 degree between
Heating set point and Cool set point (Heat is always less than Cool).
After selecting the heating set point, you cannot reduce the cooling
set point less than the heating set point.
Continue with the rest of the program
•
Press the “Select” button again - “PROGRAM 2” and “START”
(flashing) will appear will appear on display.
•
Press the “+” or “-” buttons and adjust the hours, minutes and
temperature, the same way as in PROGRAM 1
Summary of Contents for Haften TRE24-PROG-HC11
Page 16: ...16...