4
3. Installation Instructions
Installation
The ETN24-P-PD-FC-SUPER2 is designed for wall mounting in the room to be controlled.
It should be located where the occupant can easily read the LCD display and use the
controls. If the built in temperature sensor is being used to measure room temperature, the
module should be placed where the temperature is representative of the general room
conditions. Cold or warm air draughts; radiant heat and direct sunlight should be avoided.
General points to follow
•
Disconnect power to the main board before installing the unit.
•
The unit should not be installed on an outside wall or where there is an air draft.
•
The unit must not be exposed to a direct sunlight.
•
The standard height to install this unit is 1.5 meter (5 feet) from the floor.
